Back to Other
SNES Modding Service Region Free 50/60hz
SNES Modding Service Region Free 50/60hz

SNES Region Free, Switchless, DeJitter 50/60hz Modding Service

£79.16 Ex. VAT

SNES region free, switchless, deJitter DFO modding service. Free your Super Nintendo or Super Famicom from being locked to one region with this modification. Play any region Super Nintendo or Super Famicom PAL or NTSC and play it how it was meant to be played.

What does the modification do?

  • Works with all revisions of SNES or Super Famicom games console.
  • SuperCIC: Lockout chip replacement 50Hz/60Hz switch capability.
  • uIGR – Use the controller to perform resets or 60Hz and 50Hz switching.
  • Region Patch: Overrides region protection based on picture processing status reads.
  • DeJitter: Removes jitter on sync for NTSC mode.
  • DFO: Dual Frequency Oscillator, used to switch between base clocks for 50Hz, 60Hz video-modes.
  • Premium ENIG (gold immersion) finish.

 

Full Details:

SuperCIC
By holding down the reset button on the console this will switch between 50Hz (green LED), 60Hz (red LED) or Auto-Region (yellow LED). If you have a SD2SNES you are able to pair the SuperCIC with the flash card. With this you are able to switch between 60Hz and 50Hz mode. However, you need to have the uIGR, which is master for the region setting, in SuperCIC pass through mode.

uIGR
The uIGR looks at the controller inputs directly and is then able to detect certain button combinations. All button combinations are highlighted below:

Region forcing:

  • 60Hz: L + R + Select + A
  • 50Hz: L + R + Select + Y
  • Auto: L + R + Select + B
  • S-CIC pass through: L + R + Select + D-pad left OR L + R + Select + D-pad right

Reset:

  • Simple reset: L + R + Select + Start
  • Double reset (back to main menu of sd2snes): L + R + Select + X

 

Region Patch

Overwrites region if game request register $213F, where bit 4 represents the region. You also have to consider switching off the region patch if using non-original cartridges or flash cards (sd2snes with Pairmode with SuperCIC is not a problem).

DeJitter

While in NTSC mode the SNES outputs a shorter scanline in non-visible area. This might be an issue for certain TVs if you use pure analog to digital conversion without frame buffer like the OSSC does. DeJitter ‘removes’ this shorter line by pausing the clock for a few cycles. As drawback this mechanic varies output timing a bit, however the inaccuracy is neglectable when comparing it to clock variations throughout different consoles. At the moment, DeJitter is enabled by default and can only be disabled by setting jumper SJ31.

DFO

Short for Dual Frequency Oscillator. Actually in combination with the CPLD this allows to switch between three output clocks plus two colour carrier clocks.

 

The service includes:

  • Testing of the SNES or Super  Famicom beforehand
  • Full strip down of the console
  • Full Installation of the SNES MultiRegion with DeJitter QID modification
  • Testing using PAL and JAP (NTSC) gaming cartridges
  • Final testing and video taken of unit working and switching.

We can also offer a full recapping service and regulator upgrade.

 

 

OUT OF STOCK

Email me when stock is available

SKU: snes-mos-1 Category: Tags: , , , , , , ,

Related products

Atari STe Recapping Service
Atari 520 STFM / 1040 STFM Recapping Service inc PSU
Atari 520 STFM / 1040 STFM recapping service including recapping of STFM PSU, all board revisions. This service includes both recapping of the Atari STFM motherboard and PSU.
  • Check of the STFM motherboard and PSU before recapping is begun.
  • Removal of existing capacitors.
  • Clean-up and preparation of area.
  • Replace using Panasonic/Wurth/KEMET capacitors.
  • Retest (Video, Audio, Floppy Boot) using diagnostic cartridge.
We also provide a recapping service for the  Atari 520 STe / 1040 STE / 4160 STE and Atari 520 STF / Atari 1040 STF   What do you need to send? All we need is the mainboard and PSU, so please only send the board and PSU in its metal shielding. If however you choose to send the whole unit, there is an option to do that also via the choices below.  
£66.66 Ex. VAT Read more
Amiga A4000 PSU Recapping Service
Amiga A4000 PSU Recapping Service
Amiga A4000 PSU recapping service - NOTE this is NOT a repair service.
  • Removal of existing capacitors.
  • Cleanup and preparation of area.
  • Replace using Panasonic/Wurth/KEMET capacitors.
  • Test output voltages (not under load)
Recapping the Amiga A4000 PSU is a good preventive measure, the reason being these capacitors are under alot of stress (which they are designed to take of course) however with age they start getting tired which could lead to issues later on. All that needs to be sent is the Amiga 4000 PSU itself.
£29.16 Ex. VAT Add to basket
Commodore Amiga A3640 CPU Card
A3640 Accelerator Recapping Service
A3640 accelerator recapping service, all board revisions. NOTE this is NOT a repair service.
  • Check of the board before recapping is begun.
  • Removal of existing capacitors.
  • Clean-up and preparation of area.
  • Replace using Panasonic capacitors and correcting polarity of 3 capacitors.
  • Retest
Overseas recapping orders
Overseas orders are very welcome and we are able to provide you return shipping costs at the checkout. To do this add any of our recapping services to your shopping basket and then at the checkout simply fill in the billing and shipping form including your telephone and email address (important) and click the 'Request a quote' link. You will receive an email within 24hrs with the shipping cost and you can then proceed with the order by clicking on the 'Complete your order' within the email. There is no need to leave the checkout page open your web browser.  
£10.83 Ex. VAT Add to basket
Sega 32X Recapping Service
Sega 32X for Megadrive Recapping Service
Sega 32X for Megadrive recapping service for all board revisions. This service is a maintenance service and not a repair service however recapping can bring back to life your Sega 32X if it shows the following symptoms:
  • No image
  • Intermittent picture
The service includes:
  • Testing of Sega 32X using a Sega Megadrive MK1 (AKA Sega Genesis)
  • Removal of through hole capacitors.
  • Any leakage cleaned up and prepped.
  • Replacement Electrolytic capacitors soldered in place
  • Final testing and video taken of unit working.
This service is only for a recapping service for the Sega 32X add-on only.
£29.16 Ex. VAT Read more